This is the Csar watch with a 44-mm case, using the Unitas hand-wind movement, with a black stainless steel case and a stunning multi-level black dial with orange markers. The leather strap is 24-mm which means you can dress up your CSAR watch with a large number of straps. This is a very unique watch with a comfortable crown and a large exhibition case-back window to admire the Swiss Unitas Movement.

Csar Models Available: - see all CSAR models

(click image-size to enlarge)

Size: 650 | 1024	Size: 650 | 1024	Size: 650 | 1024
Size: 650 | 1024	Size: 650 | 1024

• 44mm Csar
• lug-to-lug = 56mm
• thickness = 14.4mm
• incl. crown = 49.8mm
• weight incl.band = 4.7oz
• strap length = 112.6 x 80.6mm

Csar Operating Instructions:
Everything begins with the crown, which is located on the right side of the watch at the 3pm position. The crown is already in the 1st Position, which is where you "hand-wind" or "charge" your watch, which is very important since the Airforce watch is a hand-wind model which requires winding every few days to operate.

1st Position - Wind The Watch:
In the 1st Position turn the crown clockwise 25 to 30 turns. This is called "winding the watch". You probably want to do this once every few days, just to make sure your watch is wound and runs smoothly.

2nd Position - Change The Time:
Gently pull out the crown to the 2nd Position to set the time. Once the crown is in the 2nd Position, you can change the time by moving the crown clockwise (we do not recommend setting the time backwards).

When you are done setting the time, push the crown back to its original position. This is important, otherwise the watch won't run and water or humidity might get into the watch.

Once the watch has been wound, it will run even if you remove it from your wrist. Of course after a while, the spring that you wound by hand-winding the crown will be unwound and the watch will stop. This will cause you to repeat the steps outlined above to once again get it running smoothly and accurately.